Supplies required for making the string bracelet:
- Golden Spacer Bead
- Crimp Bead
- Lobster Claw Clasp
- 0.5mm Tiger Tail Wire
- 1mm Nylon Thread
- Flat Nose Plier
- Scissors
Step1: Make spacer bead strand
1st, cut a 50cm long wire and attach a crimp bead at 5cm in the end;
2nd, slide the spacer bead one after one;
3rd, stop once the beads strand almost twice the length of your wrist circumference;
4th, attach another crimp bead at end to halt beads from dropping and adjusting the tightness among beads on wire.
crafts
Step2: Wrap about the string
1st, cut a length of 1mm nylon thread, measuring about 100cm;
2nd, fold it by 50 %;
3rd, fold you beaded strand as picture shows and loop the thread across the area between initial two beads. Bring one end going over the beaded strand and the other one going under;
4th, twist two ends together to show the cord in other. Angling down to the next gap and do this above;
5th, continue crossing over and filling in the gaps;
6th, take away the two crimp beads at ends and tie both the ends of tiger tail wire;
7th, secure two thread end having a tight knot. Make certain and then trim off any excess thread.
Wire Wrap Jewelry
Step3: Attach the clasp
Open the jumprings and fasten the clasp at end!
So, there you’ve your new string bracelet!